In Stock
$150.00 $135.00 Sale -10% OFF
-
+
  • Brand: PHROZEN 
  • Product Code: PHROZEN-WAX-LIKE

PHROZEN WAX-LIKE RESIN (LCD UV CURING RESIN): EASY TO PRINT & CAST FOR DENTAL AND JEWELRY MOLD CASTING, APPLICABLE TO 3D PRINTER, DARK GREEN (500G)


  • SUITABLE FOR: All LCD 3D Printer.
  • EASY TO CLEAN: Use alcohol spray to clean models and dry with an air gun. Do not immerse printed part into alcohol over 30 sec.
  • LOW SHRINKAGE: It’s normal for a product to shrink a little after photocuring. However, the shrinkage of this resin would be 3% only at maximum.
  • HIGH PRECISION: Details are especially well-shown when using a high-resolution 3D printer.
  • APPLICABLE TO: Lost-wax casting for jewelry & dental.

Specification & Performance

  • Weight: 500g per bottle
  • XY Resolution: 0.047 mm
  • Layer Height / Parameter: 12 sec @ 50 um, Delay 2
  • Way to Clean Printed Part: Use alcohol spray to clean models and dry it by an air gun. Do not immerse printed part into alcohol over 30 sec.
  • Compatible Printer: Phrozen 3D Printer Series.
  • Application: Lost-wax Casting for Jewelry & Dental
  • Key Performance: 
    • Viscosity: 680 mPa.S (25C)
    • Density: 1.21 g / cm3
    • Hardness: Shore 65D

About Resin Operation

  • Avoid sunlight exposure.
  • After printing, stored used resin in a closed and opaque bottle.
  • DO NOT mix the fresh resin and used resin. 
  • Shake or stir resin properly to avoid pigment separation.
  • DO NOT dump resin. Please cured resin and treat/recycle it as general plastics garbage.

Safety Recommendation

  • Do your best to wear gloves, goggles, long sleeves shirt during usage of resin. Wash hands after every operation.
  • DO NOT swallow resin. Go to the hospital if you do it.
  • Avoid eye contact with resin. Rinse with water and go to a hospital if resin contacts eyes.
  • The resin might cause slight skin irritation. Stop using it if allergy occurred.
  • Resin smells. We strongly suggest you use it under a ventilated condition.
  • Keep resin in room temperature(15 - 35 Celsius) and dry condition.
  • Keep resin away from the kid.

Write a review

Note: HTML is not translated!
Bad           Good